Vinyl Installation Instructions

Installation Instructions for Pre-Cut Vinyl Decals (with Transfer Paper)

Tools Needed:
    •    Pre-cut vinyl decal (with transfer tape)
    •    Squeegee or credit card (with soft edge)
    •    Isopropyl alcohol (70%+)
    •    Microfiber cloth
    •    Masking tape
    •    Measuring tape or ruler
    •    Scissors (optional)

Step-by-Step Instructions:
1. Clean the Surface
    •    Wash with soap and water. Dry thoroughly.
    •    Wipe the area with isopropyl alcohol to remove any residue.
2. Position the Decal
    •    Keep the backing on. Place decal where you want it.
    •    Use masking tape on the top edge to create a hinge.
    •    Measure and adjust alignment.
3. Apply Using the Hinge Method
    •    Flip up the decal and peel the backing paper off slowly.
    •    Hold the transfer tape taut and begin lowering it back down.
    •    Squeegee from the center outwards to remove air bubbles.
4. Remove the Transfer Tape
    •    Slowly peel the transfer tape off at a sharp angle.
    •    If vinyl lifts, press back down and squeegee again.
5. Final Press
    •    Go over the decal again with a squeegee or soft cloth.
    •    Press edges and fine details to ensure adhesion.

Aftercare
    •    Avoid washing the vehicle for 24 hours.
    •    Don’t use pressure washers or harsh chemicals on decals.

Website: racerxcustoms.com


Phone: (619) 749-0355


Made in the U.S.A.